TT Plate Carrier
LP LC Frame

Lightweight Plate Carrier Reinforced
with Tegris^®

Highlights

The TT Plate Carrier LP LC Frame is made with Tegris^® material. This ensures a combination of lightness and great stability. The material also allows a very flat construction, especially in the chest and collarbone area, which optimizes freedom of movement.

Suitable for SAPI panels up to 30 x 25 cm
Tegris^® Frame System
Cummerbund reinforced with Tegris^® material and including removable MOLLE panels
Additional elastic low-profile cummerbund with magazine slots
MOLLE system in laser-cut design

Features

The plate carrier features hook-and-loop areas on the front and back. Panels for magazine pouches can be hooked onto the front or attached with buckles. The back is equipped with MOLLE in laser-cut design.

Shoulder straps
adjustable in length
Shoulder pad
adjustable and removable
Side attachment
elastic, length-adjustable and fixable
Hook-and-loop area
on the front and on the back
Laser-cut MOLLE
on the back

Tegris^® Cummerbund with MOLLE Panels
The cummerbund features laser-cut holes at MOLLE intervals and can be clipped into two height positions on the front. An elastic fastening element on the cummerbund ensures freedom of movement and length adjustability. There are flat hook-and-loop MOLLE panels on both sides, which make it possible to quickly swap and remove equipment.
Replacement Cummerbund with Magazine Pouches
A lightweight, elastic cummerbund with three magazine pouches on each side (M4 size) is also included.
MOLLE Hook and Loop Patch for Admin Panels etc. on the Front
There is a hook-and-loop patch with slots and attachment holes on the front. Admin panels, radio modules (e.g. Peltor modules) or fold-down holders for cell phones or controls can be attached here.